Tell A Friend About This Page!

 
NewAge Plastic Tubing, Hose, Fittings, and Clamps

HOT BOND® - THERMAL BONDING

 
Go Back to Custom & FabPage
PEP- Home

isa process by which thermoplastic tubing or hose is bonded together usinga proprietary heat process into a neat ribbon, offering the uncommon combinationof reduced cost and improved aesthetics to your product. No solvents, whichcould migrate and cause contamination of adjoining surfaces or materials,are used in the bonding process.
 
  


Various sizes, quantities, and configurations make iteasy to design HOT BOND into a new product or to retrofit an existing item.		 The blend of the HOT BOND process and NewAge® Industries' vasttubing and hose inventory provides faster delivery, at a lower cost, thana typical custom extrusion. Prototyping is easy, and both long and shortruns are equally cost effective and welcome.

The HOT BOND® process can be applied to either stock tubing or hoseor to custom extrusions. NewAge® Industries can HOT BOND reinforcedhose to unreinforced tubing, half inch to three quarter inch sizes, coloredto clear; the choices are nearly endless. Then we can cut, coil, stripback, or assemble as necessary. The final product can be finished as needed.

 TOP OF PAGE

WHY HOT BOND?

 
. Saves time and money on installation
By eliminating the repetitive effort needed for multiple routing duringinstallation, a savings of 50% or more can be realized. 
. A neat appearance
HOT BOND visually shows your attention to design while enhancing the overallquality of your product. 
. Easier line traceability
Quick troubleshooting translates into saved time and expense. 
. Saves space
A ribbon of bonded tubing and hose is more exact in dimension than a bundle,permitting a more compact design. 
. HOT BOND is available only from NewAgeIndustries.		 
Trace lines quickly and easily with different colors.
 TOP OF PAGE

CHOOSE YOUR BOND STRENGTH& CONFIGURATION

  
. PERMANENT BOND
Offering maximum durability, permanently bonded tubing and hose will notseparate without cutting tools (which should be used carefully to leavethe tubing or hose wall undamaged).
 
. STRIPPABLE BOND
Provides flexibility during installation by permitting separation of individualtubes from the "ribbon" for fitting purposes. Tools are typically not needed--simplytwist the tubing or hose at the bond and peel back--a quick and easy process.
 
Two or more tubes are possible in many configurations,up to a maximum finished width of 2-1/8".
 TOP OF PAGE

NewAgeIndustries' fabrication engineers can HOT BOND electrical wire and lightcable to tubing or hose to meet the needs of electropneumatic service.Standard PVC or TeflonT® jacketed wires can be mated to tubing or hoseof similar material to meet your requirements. Contact your representativefor details and assistance.
 
  


Simplify your electropneumatic connections. A cleaner,easier-to-manage, faster installation will give your product the competitiveedge.		 
Electrical lines, from jacketed light gage wire to cable,can be bonded to tubing and hose of similar material.

 TOP OF PAGE
BACK TO CUSTOM & FABRICATIONMAIN PAGE
PEP- Home